Previous
Next

SATELLITE FINDER KIT With SIGNAL METER + COMPASS ΚΙΤ ΕΡΓΑΛΕΙΩΝ ΕΓΚΑΤΑΣΤΑΣΗΣ ΔΟΡΥΦΟΡΙΚΟΥ ΣΥΣΤΗΜΑΤΟΣ

Reference: SAT FINDER KIT
€16.00
Tax included

Input Frequency: 950 ~ 2300 MHz, Works With Every satellite out there
Completely Lighted With Audio Tone
Power: 13-18V supplied by Receiver OR BATTERY
Size: 77 x 60 x 28 MM
Instructions Included 
     
Compass Included
POWER SUPPLY INCLUDED (Battery Not Included)

Instructions:

SATELLITE FINDER OPERATION:

  1. Unplug the receiver from the wall.
  2. Remove the coax from your LNBF.
  3. Connect the coax to the  meter to the connection that says "TO REC".
  4. Using a jumper coax connect to the side of the meter that says "TO LNB".
  5. Connect the other end of the jumper coax to the LNBF.
  6. Plug in and power up your receiver.
  7. Adjust the signal level knob on the front of the meter so the reading is below 5 on the scale.
  8. Do a rough adjustment for the azimuth and elevation of the dish to get a starting point. (Using the compass)
  9. With your signal level at or below 5 on the meter, start to adjust the dish very slowly while watching the meter. 
  10. Power down the receiver by unplugging the power cord.
  11. Remove the meter and re-connect the coax from the receiver to the LNBF.
  12. You are now ready to power up your receiver.
SAT FINDER KIT

Data sheet

SATELITE
ΠΕΔΙΟΜΕΤΡΑ - SAT FINDERS