Previous
Next

Qoltec EV Cable Type 2 for car charging | 400V | 22kW | 32A | 5m

Reference: 22kW | 32A | 5m
€249.00
Tax included

cable is 10 meters long and Type 2 (16A)

With this cable, you can charge your EV/PHEV that has Type 2 port with an EV charging station that has Type 2 socket. The cable is 16 Amp, single-phase, can charge your EV up to 3.6 kW. The product has a nice appearance, a hand-held ergonomic design and is easy to plug. The working length is 10 meters and is made from thermoplastic material. It has protection level IP55, is anti-flaming, pressure-resistant, abrasion-resistant and impact resistant.

 

How to use:

We recommend to use the following steps:

1.Plug in the Type 2 male end of the cable to the charging station

2.Plug in the Type 2 female end of the cable to the car’s charging socket

3.After the cable has clicked in place you are ready for the charge*

*Don’t forget to activate the charging station

When you finish with the charge, disconnect the vehicle side first and then the charging station side. Remove the cable from the charging station when not in use.

How to store:

The charging cable is the lifeline of your electric vehicle and is important to keep it protected. Store the cable in a dry place preferably a storage bag. Moisture in the contacts will result in the cable not working. If this happens place the cable in a warm and dry place for 24 hours. Avoid to leave the cable outside where the sun, wind, dust and rain can get to it. Dust and dirt will result in the cable not charging. For longevity, ensure that your charging cable is not twisted or excessively bent during the storage.

The EV+ Charging Cable Type 2 to Type 2 16A 1 Phase 10m is very easy to use and store. The cable is designed for both outdoor and indoor charging and it has IP55 (Ingress Protection). This means that it has protection from dust and splash of water from any direction.

22kW | 32A | 5m

Data sheet

POWER SUPPLY VOLT
EV CABLE 32 AMPER